jtag/drivers/am335xgpio: do not configure push-pull inputs as output

Previously, if a pin was configured as ADAPTER_GPIO_INIT_STATE_INPUT and
its drive value was ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL, initialize_gpio
would configure the pin as an output.

The set_gpio_value function is optimized to not set the direction for
pins configured as ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL as it only needs to
be set once. When initialize_gpio performs this setup, it checked only
that the drive value was ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL to set the
output direction but did not exclude input pins which have already had
their direction set.

Now, input pins are ignored when initialize_gpio checks for
ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL to set the mode to output.

Fixes: ace0282 ("drivers/am335xgpio: Migrate to adapter gpio commands")
Change-Id: I9ea502c400ea4ffae37080b9cee891ca9176a47d
Signed-off-by: Vincent Fazio <vfazio@xes-inc.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/7877
Reviewed-by: Tomas Vanek <vanekt@fbl.cz>
Tested-by: jenkins
Reviewed-by: Steve Marple <stevemarple@googlemail.com>

src/jtag/drivers/am335xgpio.c

@@ -184,7 +184,8 @@ static void initialize_gpio(enum adapter_gpio_config_index idx)
 	}
 
 	/* Direction for non push-pull is already set by set_gpio_value() */
-	if (adapter_gpio_config[idx].drive == ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL)
+	if (adapter_gpio_config[idx].drive == ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL
+		&& adapter_gpio_config[idx].init_state != ADAPTER_GPIO_INIT_STATE_INPUT)
 		AM335XGPIO_SET_OUTPUT(&adapter_gpio_config[idx]);
 }