2.2 Configure your ftcSoundBar's via WEB UI

Once you managed to connect you ftcSoundBar to the local wifi network, you could configure it using the web-UI.

Connect to your http://ftcSoundBar. Use the setup-icon to configure your ftcSoundBar:

firmware version	running version of ftcSoundBar's firmware
hostname	The hostname of your ftcSoundBar. You could configure it in the ftcSoundBar.conf file. Don't change this value, if there is only one ftcSoundBar in your local network. If you change it, you need to set the IP-Address of your ftcSoundBar in all ROBOPro programs.
ip address	Ip-address of your ftcSoundBar.
startup-volume	Volume of your ftcSoundBar after start or reboot
i2c mode	Turn this switch on, if your want to communicate with your ftcSoundBar via i²c-interface. If you don't want to use i²c, this switch should be off. Technically, the i²c-bus shares the IO-pins with the touch buttons Play, Set, Vol- and Vol+ on your ftcSoundBar. Enabling this feature, the buttons on your board won't work.
tct client mode	Turn this switch on, if you want to use your fischertechnik TXT controller in AP mode. Turn it off in all other cases. In AP mode, the TXT's DHCP service is not stable. Sometimes, your ftcSoundBar won't get a ip-address. This switch sets a static IP for the ftcSoundBar.
wifi SSID	The SSID of your local network.
preshared key	The preshared key / password of your local network.
update firmware	Don't care, if this button isn't shown. It's available, if there ist a `ftcSoundBar.bin` file at the SD-Card.
save configuration	This button stores all of your changes in the `ftcSoundBar.conf` file and reboots the device.