-
Notifications
You must be signed in to change notification settings - Fork 2
Home
Welcome to the ftcSoundBar's online manual. This manual describes how to build your own ftcSoundBar and to use it with different controllers.
Chapter 1: Setup your ftcSoundBar
This Chapter describes how to build up your own ftcSoundBar from scratch. If you prefer to work with a prebuild system, you could purchase one at http://www.gundermann.org/shop. If you have already a ftcSoundBar please continue with chapter 2.
1.1 Build your own ftcSoundBar hardware
1.2 Build the software
1.3 Flashing the firmware
Chapter 2: Configuring the ftcSoundBar via SD-Card and WEB-UI
2.1 Connect your ftcSoundBar to your wifi network
2.2 Configure your ftcSoundBar's via WEB UI
2.3 Configure your ftcSoundBar by editing the config file
2.4 Uploading sound files
2.5 Update firmware
Chapter 3: Using the ftcSoundBar
3.1 WEB-UI
3.2 fischertechnik TXT
3.2.1 ROBOPro using local wifi
3.2.2 ROBOPro using TXT's AP wifi mode
3.2.3 ROBOPro using i²c-bus
3.2.4 CFW and python using wifi
3.3 fischertechnik TX
3.4 ftDuino
3.5 TX-Pi
3.6 ATMEL-based Arduino boards
3.7 esp-32 family
3.8 Raspberry Pi