Modules not working

[Lolagatorade]

Category

Hardware Compatibility, Other

Hardware

Heltec V3

Firmware Version

2.4.2

Description

Bme680, gps module neo-6m, vibration motor ect. Have not been functional or have been very buggy. The only one I have been able to get to work is a vibration motor and it was not straightforward. As of now I’m trying the BME680. On sda and scl pin and it is also not working after enabling it in telemetry. I don’t know if it’s a firmware issue because on the last few releases, it’s also been nonfunctional.

What does happen is the screen slowing down and freezing and the buttons not being responsive for a while and eventually it recovers after a reboot, but there is a noticeable slowdown on the system when these modules are connected, even though they are not recognized or functional
Meshtastic Application Logs.csv

Relevant log output

No response

[Lolagatorade]

Ex bme board was configured as such. It can also be seen the vibration motor currently disconnected with a diy LC circuit:

[Lolagatorade]

Tested on 17 and 18 as some reported to get it to work but and got it to work... there should be a guide as to what pins function as what... or a way to reconfigure it within the app... either way these are not official pins on the gpio