Write an assembly program that simulates a single-digit counter (0-9) that: increments on the rising edges of RB4 (by interrupt); decrement on the rising edges of RB5 (by interrupt); automatically initializes if its value reaches the maximum value of 9; it can be initialized by the operator using an interrupt on RB0. Modify your program to add an LED that blinks as long as the counter=0 by: Using a timer based on timer0 of 250 ms (Osc=16MHz)

[0714627380]

TODO: ADD YOUR QUESTION/PROBLEM DESCRIPTION HERE

---

Before submitting this issue, please consider the following checklist:

• Consult the FAQ and Known Issues pages.
• Make sure maplab was installed using the proper installation instructions
• For bugs and build problems please add (if applicable):
  • Version of:
    • Operating System (32/64bit, 14.04/16.04/...)
    • Eigen
    • ROS
  • A backtrace (if maplab crashed)
  • Run catkin config in your workspace and post it here.
  • Details about the commands/scripts used.
  • Details about special parameter values or manual changes to the system.
  • Pictures/screen recordings
• For general questions:
  • Please elaborate, we are no mind readers :)