Failed to flash arm trusted firmware to Jetson TX2

[Alan-Kuan]

Hi,

I followed the instructions from bao-demos to install bao on Jetson TX2. However, I stuck at the step to flash arm trusted firmware to Jetson TX2. After the flash command started, it hung for almost an hour. I had nothing to do but interrupt the process.

I am seeking for help to successfully flash the firmware. The followings are some information that might be helpful.

I'm sure the board was in recovery mode.

During the flashing, it showed a message BootRom is not running.

[danielRep]

Hi @Alan-Kuan , I'm addressing this issue right now here

[Alan-Kuan]

Hi @Alan-Kuan , I'm addressing this issue right now here

Ok. Thank you!