You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Once an internal address (iAddr:iPort) is mapped to an external address (eAddr:ePort), any packets from iAddr:iPort are sent through eAddr:ePort.
Any external host can send packets to iAddr:iPort by sending packets to eAddr:ePort.
Single sided hole punching would be sufficient.
Address Restricted Cone NAT
Once an internal address (iAddr:iPort) is mapped to an external address (eAddr:ePort), any packets from iAddr:iPort are sent through eAddr:ePort.
An external host (hAddr:any) can send packets to iAddr:iPort by sending packets to eAddr:ePort only if iAddr:iPort has previously sent a packet to hAddr:any. "Any" means the port number doesn't matter.
Require coordinated 2 sided hole punching.
Port Restricted Cone NAT
Once an internal address (iAddr:iPort) is mapped to an external address (eAddr:ePort), any packets from iAddr:iPort are sent through eAddr:ePort.
An external host (hAddr:hPort) can send packets to iAddr:iPort by sending packets to eAddr:ePort only if iAddr:iPort has previously sent a packet to hAddr:hPort.
Require coordinated 2 sided hole punching.
Symmetric NAT
Each request from the same internal IP address and port to a specific destination IP address and port is mapped to a unique external source IP address and port; if the same internal host sends a packet even with the same source address and port but to a different destination, a different mapping is used.
Only an external host that receives a packet from an internal host can send a packet back.
Not Punchable, Relay is needed.
The text was updated successfully, but these errors were encountered:
Created by @CMCDragonkai
The following discussion from 'Refactoring Network Module' MR should be addressed:
@Zachaccino: (+2 comments)
The text was updated successfully, but these errors were encountered: