forked from MarlinFirmware/Marlin
-
-
Notifications
You must be signed in to change notification settings - Fork 220
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
CR-10 Smart Can't change Z-axis offset #264
Comments
Also facing this issue. The desired Z-offset also is not saved if you adjust and save mid-print. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I've autoleveled the bed, but if I try to change the z-axis offset, it updates for one frame and then changes back to 0.20. This happens in any page where you can change the offset including mid-print.
0.20 is too close to the bed to be able to extrude.
The text was updated successfully, but these errors were encountered: