-
Notifications
You must be signed in to change notification settings - Fork 434
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Routers Cannot Communicate after Enabling RIPv2 #3640
Comments
Router configurations are correct. |
Interesting. Mine works as well right after configuration, but after about 5 minutes, their communication starts to corrupt. The reason I discovered this was that I left my computer running for some time and then went back to check. By the way, it was running, not sleeping or locked. |
No problems also after a few hours or resuming from suspension. |
Describe the bug
First I configured RIPv2 on three Cisco IOSv15.9(3)M6 routers that are connected to each other. After some time, they cannot receive each other's RIP update request. They also cannot ping each other, and I can't even start a packet capture to see what's going on.
Because I can't even start a packet capture, I suspect this is a problem of GNS3.
GNS3 version and operating system:
To Reproduce
Steps to reproduce the behavior:
and use the
network
command to add the interfaces that should have RIP activated on.3. Here are the interface and RIP statuses of R1,2&3.
R1
R2
R3 (With output from
debug rip ip
)show ip protocol
anddebug ip rip
.404 not found
error. Wireshark will be shown as blank.Running-config of all three routers
(Somehow I accidentally restarted R2 and forgot to save the running config, but I configured it again, so things might be a little bit different than what was originally)
The text was updated successfully, but these errors were encountered: